Specifications
INTERSOURCE CONTINUOUS AUTOMATIC CHIP PROCESSING SYSTEM WITH PNEUMATIC DISCHARGEGeneral Specifications
Screw conveyor
Batch processing is possible by allowing
chips to accumulate in receiving hopper
while screw conveyor delivers a positive
metered feed over a wide range of
material and chip configurations.
Parts separator with M2-4836 15Hp shredder
A high percentage of parts, bar ends and
tooling are recovered from chips before
processing.
Chip wringer CA-6200E
30 inch continuous design provides
maximum efficiency and reliability in oil
recovery, reducing oil cost, waste and
environmental problems. The result is the
dryest, cleanest chips possible.
Pneumatic discharge
Dry chips are conveyed from the wringer
through the plant to holding containers
remotely located from the system. Dry
chip pneumatic conveying force is created
by the chip wringer; no additional blowers
or compressors are required.
Oil collection tank with chain sludge conveyor
Acts as primary filter by allowing
recovered oil to accumulate while
sediment settles to tank bottom and is
conveyored out.
Electric controls
Fully programmable controller provides
sequential start ip, inter-lock safety
features and component status
monitoring, cutter hammer PLC.
Motor Specifications
20 Horsepower chip wringer main motor 230/460
Conveyor motors
Pump motors
Serial Number 35264-D
Year 2000