Sold!
Buy one like this

I want to sell a machine like this

  • Automatic
  • Acme Gridley
  • 1" RAN 6
  • Multi Spindle Bar
  • 6 Spindle
  • 1970

Specifications

Maganize Bar Feed
High Speed Drilling
Accelerated Reaming
5 Independent Cross Slides
Cams and Gears
Chip Conveyor
Cross Slide Tool Holders
Hinged Type Drill Saddles
Motors & Electrical Controls
One Set of Cams and Gears
Outboard Coolant PumpSplash Guards
GENERAL SPECIFICATIONS
HeightTo Top Of Motor : 6'4"
Length: 7'8"
Net Weight: 10,900 Lbs
Width: 3'7"
Collet Capacity Round 9/16"
Collet Capacity Hex 1/2"
Collet Capacity Square 25/64"
Idle Time .92 Seconds
Spindle RPM if Stopper 2370Spindle Speeds 321-3200
S tandard Horsepower 15
Stock Feed Travel: 5"
Tool Slide Travel Main 3 3/8"

Notes

Very good machine stored in the South. The machine has a magazine bar feed built by Accro feed . It also has gearbox milling and extra tooling. |Schematics, books etc all with the machine. .006 carrier drop at 12 o'clock.|1st position cross slide bracket is broken and the slide has a piece out of it about as big as a quarter.|Some positive stop nuts are broken|Main worm is like new. |Machine runs very quiet.