I want to sell a machine like this
- Automatic
- Acme Gridley
- 1-1/4" RA 6
- Multi Spindle Bar
- 6 Spindle
- 1955
Specifications
Universal Threading Pos.45 Independent Cross Slides
Chip Conveyor - Universal
Flat Tool Slide
Hinged Type Drill Saddles
Motors & Electrical Controls
One Set of Cams and Gears
Outboard Coolant Pump
Splash Guards
Stock Reel And Stand
Length 9'5"Height To Top Of Motor 6'10"
Weight 13,800 Lbs
Width 3'7"
***GENERAL SPECIFICATIONS***
Collet Capacity Round 1 1/4"
Collet Capacity Hex 1 3/32"
Collet Capacity Square 7/8"
Idle Time 1.8 Seconds
Main Tool Slide Travel 6"
Spindle RPM if Stopper 2128Spindle Speeds 265-24 75
Standard Main Motor 25 Horsepower
Stock Feed 7"
Notes
Machine has no tool slide lift and has .006 at 10 and 2 o'clock carrier lift. Tool slide no lift and the tooling area is real nice thats the good news - the bad news is: the back end needs rebuilding and the spindle bearings need to be replaced. The indexing plate has some wear, Main spindle drive shaft needs replacing.