Sold!
Buy one like this

I want to sell a machine like this

  • Automatic
  • Warner & Swasey
  • 1-1/4" 6 M-3300
  • Multi Spindle Bar
  • 1960

Specifications

6 Cross Slides
Height 6' 10 1/2"
Length 112
Weight 14,500 Lbs
Width 46
Bar Feed Stroke 0 - 10
Cross Slide Stroke 0-13/16
Cutoff Stroke 0 - 7/8
Idle Appr Stroke Standard 3.5"
Ind Ream Stroke 3/16 - 3 3/4"
Max Length Turn Standard 8.5"Speed Range 255-2781 RPM
Spindle Capacity Round 1 1/4"
Spindle Capacity Sq 7/8"
Spindle Capacity Hex 1 1/16"

Notes

Two machines available from the same facility in the southeast; the other serial is 1,790,969 and is a double feed machine new in 1960 - machine was rebilt in 1989 at a cost of $70,000 each. ||Photographs are available Immediately upon request. All the tooling is included.|Machine equipped with: (approximately)3 Knee tools, 3 low roll supports - 2 high, 4 roller turners, 1 circle form, 1 shave, 2 low flat forms - 1 high, 2 cutoff holders, 4 auxilairy slide plates, 6 feed tubes, 18 sets of collets. Wired 480 volt, motors are dual voltage. Stem, gear box, fulcrum arms, back end, bronze gear, cross slides, all very good.|Machines were rebuilt by AMR Industries, 7725 S. 6th St., Oak Creek, WI 53154.