Sold!
Buy one like this

I want to sell a machine like this

  • Automatic
  • New Britain
  • Model 62
  • Multi Spindle Bar
  • 6 Spindle
  • 1975

Specifications

Universal Threading Pos 5
Hydraulic Threading Clutch
Auxiliary Front
6 Independent Cross Slides
Chip Conveyor - Universal
Thread Rolling Attachment
Master Collets and Pushers
Cross Slide Tool Holders
3 Phase 60 Cycle Electrics
Motors and ControlsPusher Tubes
Speed and Feed Gears
Stock Reel And Stand
STANDARD SPECIFICATIONS
Height: 6'5"
Length:12'
Weight:19,000 lbs
Width:4'8"
Cap. Round: 1 5/8" or 2 1/4"
Coolant Capacity 130 Gallons
Idle 1.66 w/6" Tool Slide Cam
Max Die Head Dia: 5 1/4"Max Feed Lower Slides 1.655"
Max Feed Mid Slides 1.504"
Max Feed Top Slides 1.504"
Max Stock Feed 7 1/2"
Max Trav Lower Slides 2 9/16"
Max Trav Mid Slides 2 5/16"
Max Trav Top Slides 2 5/16"
Motor Horsepower 15-30 at 1800 RPM
Spindle Speeds 177-2519

Notes

Machine is in excellent condition run very little since being rebuilt in 1988 by N.B. Rebuilders of North Carolina. Wired 220 on dual voltage.|Tooling includes (APPROXIMATELY) 25 helical and 15 straight gears, shave tool, 21 cross slide cams, 10 feed cams, 20 auxiliary cams, 3 dove tail holders, 3 flat form holders, cutoff holder, sliding base holder 6th and several sets of collet pads.|Condition: Gear Box: Excellent, back end: very good, carrier area: excellent. Tool slide lift - none. |Machine ran approx imately 1500 hours since rebuild mild steel with oil.