Specifications

Change Gears
Miscellaneous Dies
V-Type Ram Design
3/4"- 2.5" Thru Feed Capacity
3/4"- 4" In Feed Capacity
Three Die Horizontal

Notes

This machine may be viewed under power in Knoxville Tennessee. It was used most recently for rolling splines on the ends of steel shafts approximately 2" in diameter x 3" Long. It has a 2 1/2" Diameter "C" Spindle, a 4" wide die holder assembly and a 15 H.P. Main drive motor. There is a new idler included with the machine.||This machine is not set up for through feed.