Sold!
Buy one like this

I want to sell a machine like this

  • Automatic
  • Davenport
  • HP
  • Multi Spindle Bar
  • 20 mm
  • 2008

Specifications

Bar capacity (maximum)
0.875 inch (22.2 mm) round
0.750 inch (19.1 mm) hex
0.625 inch (15.9 mm) square
Bar capacity (minimum) 0.187 inch (4.8 mm)
Turning length (maximum) 3.0 inches (76.2 mm)
Stock depletion sensor yes
Burring spindle sensing mechanism yes
Number of main (work) spindles 5
Main spindle speed range 0-3,800 rpm
Number of independent longitudinal tool stations 5
Cross slides 2
Tool arms 2
Spindle pick-off and deburring Yes
Spindle capacity diameter pick-off (maximum)
0.875 inch (22.2 mm)
Number of tools servicing pick-off spindle
1 (2 with Two Position Backworking Option)
Tooling positions 9 (plus attachments)
Spindle indexing time 0.3 seconds minimum variable
Control make and model
Davenport Controller
Shop Air Pressure 90 psi (Option Dependant) ( up to 20 cfm)
Total power requirement 24,000 Watts
Clear area required for installation
20’L(609.6cm) x 15’W(457.2cm) x 10’H(304.8cm)Machine weight - 6,100#
9’4”L(284.48cm) x 4’6”W(137.16cm) x 8’10”H(269.24cm)
Cucchi Bar Loader weight - 4,000#
18’L(548.64cm) x 2’9”W(83.82cm) x 4’1”H(124.46cm)
Stock Carrier Cover weight - 250#
8’6”L(259.08cm) x 19”W(48.26cm) x 21”H(53.34cm)
Stock Carrier weight - 225#
10’4”L(314.96cm) x 11-1/2”W(29.21cm) x 11-/2”H(29.21cm)
Transformer (if required) weight - 325#
16”L(40.64cm) x 28”W(71.12cm) x 32”H(81.28 cm) Controls Package - 1200#
60”L(152.4cm) x 60”W(152.4cm) x 60”H(152.4cm)
Constant Low Pressure Lubricator #SB-2446-1
(Ways and Servo Motors)
Required Lubricant Mobil Vactra (Heavy)
Reservoir Capacity 8 Liters
Lube Pump Output 100 cc/min.
Pressure Setting 25-30 psi
System Voltage 480 V, 50/60Hz 3 Phase, 50 Amp

Notes

One (1) Davenport, Model B Servo Hp, 2008
Complete As Follows:
Pietro Cucchi Magazine Loader
CNC Pickoff
CNC 2 Position Back Working
CNC Threading
up Lift Chip Conveyor
All Tooling Necessary to Turn-Key Part 2009 Boat Tail Ferrel for a 5 Second Cycle. Operation Would Shave O.D. in Order to Hold .003 Center for I.D. to O.D.
Warranty - Six Months for Parts and Labor
Delivery - 6 to 8 Weeks
Deposit of $75,000.00 Is Required With the Order
an Additional $75,000.00 Is Due Upon Acceptance of Parts from Runoff. Balance of Funding Is Due 30 Days After Receipt to Your Floor
Installation on Your Floor With 5 Days Training Is Included With Order
Freight to Your Facility Is Your Expense.