Back to List

Request Quote

Sell one like this

  • Chip Processing
  • APPLIED RECOVERY SYSTEMS
  • Puck System
  • 2006

Notes

AGE: 2006
The dies show no wear. This machine will salvage at least 98% of the cutting oil used in the machining process.
SPECIFICATIONS:
Production Rate: 1200 Lbs. per Hour - Steel/Cast Iron
600 Lbs. per Hour - Aluminum
1600 Lbs. per Hour - Brass & Copper
Briquette Diameter: 2.75"
NOTE: Less then 2% Moisture Content
Motor Data: 20 HP, 480/3/60
Original Cost in 2006 was $94,032.00
Condition: Like New
Available for viewing with available process people who have knowledge about the workings of the machine. See attached pictures of the pucker machine. It has very little use. It was used to puck aluminum turnings. The dies show no wear. This machine will salvage at least 98% of the cutting oil used in the machining process. While in use it was left to run on automatic with aluminum turnings being fed into the machine. Then the pucks were pushed out into two side by side bins